|
PDF/Print Version |
|
Add to Watchlist
|
|
Calculator |
|
Comparison >> |
|
|
|
|
| Customer review |
|
 |
|
Brief Introduction
Beta 2.5 |
The standard portable Benq PB8250 DLP projector has 3000 Ansi lumens, a contrast of 2000:1 and an XGA 1024 x 768 resolution. An image width of up to 477 cm is possible as the projector has 3000 Ansi lumens. However, if room light is available, the picture should be max. 318 cm wide. The model built in 2004 is no longer offered by Benq.
|
| Display Type |
1 x 0,7" 12 Grad DLP Chip
XGA 4/3 Ti Digital Light Processing Chip
|
| Ansi-Lumen |
Projector |
3000 / 2400 im Eco Mode |
Screen |
1000 Lux (200 cm Screen width) |
| Contrast |
2000:1 full on/off |
2000:1 full on/off 
|
| Black Level |
1,5000 min. Lumen |
0,501 min. Lumen |
| Offset |
69% show
|
| Resolution |
XGA 1024 x 768
786.432 Pixel
SXGA 1280 x 1024 compressed |
| Video Modes |
PAL, SECAM, NTSC, EDTV HDTV 720p, 1080i, |
| Application |
Standard-Portabel | External training and company presentations, as well as product presentations.
Medium screen width or rooms with a little more ambient light, max. 200 lumens. |
| Light Source |
300W UHP Lamp
Article Nr.: 59.J8101.CG1
|
|
| Light Life |
2000 h. 3000 h. in Eco Mode |
| Operating Costs |
-
|
|
328 - 402 cm
|
 |
|
Lux: |
1000 Lux |
|
Room light max.: |
200 Lux |
|
Candela pro m²: |
319 cd/m² |
|
Foot-Lamberts: |
93 fL |
|
 |
| 104 cm
|
|
Screen width: 200 cm Gain:1 |
|
|
| Focus |
Manual |
| Zoom |
Manual 1,21 |
| Objective |
F=2,4-2,6 f=24-29,1 mm |
| Throw Ratio |
1,64-2,01:1 show |
| Audio |
2 x 1W |
| Connections |
DVI-I mit HDCP
D-sub 15pin in und out
Cinch Video in
Cinch Stereo in
S-Video in
USB
Mini Jack
 |
| Ceiling Mounting |
Yes, is possible. |
| Power |
395W |
| Size WxHxD |
320 x 105 x 236 mm (12,6"x4,1"x9,3") 7,93 L/dm³
|
| Operating Noise |
35 / 33 dB in Eco Mode |
|
| Weight |
3,50 kg / 7,72 lbs. |
| Keystone |
Vert.: +/-16°
|
| Illumination |
85% |
| Frequenz |
H-sync: 20-88 kHz
V-sync: 20-100 Hz
|
| Foot-Lamberts |
93 fL
/ max. 477 cm screen width |
| Candela m² |
319 cd/m² |
| Features |
 Freeze
Blank (Black screen button)
Eco Mode
Kensington Slot
Picture-in-Picture
Remote control with laser pointer und mouse control
Digital Zoom
4 segments colour wheel 2x speed
|
|
- |
In Comparison
The Benq PB8250 compared to others not current "Standard-Portabel" projectors. |
| Ansi-Lumen: |
|
36 |
Weight: |
|
83 |
| Contrast: |
|
1 |
dB: |
|
36 |
| Black level: |
|
94 |
Power cons.: |
|
95 |
| Picture Total Points: | 44 |
Projector Total Points: | 71 |
|
| Popularity Top 100 |
|
| Points: |
|
15 |
| Ranking: |
406 (From: 7662) |
|
|
|
| In Test
|
-
|
|
|
| Status |
2004 Discontinued (EOL) // Last update of the data: 2023-08-04
|
| Data |
 Product Sheet english
Product Sheet english HC
Product Sheet französisch
User Manual english (7.46 MB)
              
|
|
|
Autor:
Martin 15.03.12 |
|
3 Stars |
Fan on max loud |
|
The fan runs immediately at maximum and never goes back.
|
|
|
Autor:
Frankfurter 28.11.09 |
|
3.5 Stars |
Not bad but not the best projector experience either. |
|
Bought the thing used with about 1000 hours for 700 euros.
From time to time the thing goes crazy and shows overheating, but after a ten-minute break you could switch it on again and it went on without any problems.
Then changed the lamp at 2000 hours after a lamp failure, which then burned for 2100 hours but then everything was only red after a short bang and that was it.....
Repair offer was too expensive at over 500 euros now I‘ve switched to Optoma.
|
|
|
Autor:
Chris 29.10.08 |
|
3.3 Stars |
Why no HDCP? |
|
Why can‘t the Bemaer support HDCP?
It says above that it would be possible via DVI-I socket.
Please ask for clarification.
|
|
|
Autor:
Manuel Unnewehr 09.07.08 |
|
3 Stars |
pb 8250 |
|
I bought the projector at the end of 2005 for 2000 euros.
The projector can be recommended at any time, very high light output and suitable for professional use. However, it does not have HDCP. Therefore not suitable for Premiere HD, Bluray etc. Unfortunately, this is also a disadvantage that I had to experience. After only 30 hours of operation, the device very soon started to turn its fans up to maximum speed, making it very loud. A few hours later, the device switched itself off because the lamp temperature was supposedly too high. However, the error did not always occur at first. after approx. 100 hours, operation was no longer possible. After sending it under warranty, a wrong appliance was returned weeks later, which I then had to send back until I received my own appliance again. Unfortunately, after a short time I had the problem again....
|
|
|
|
Benq Website
